Uninterrupted AC power (UPS function)
Power Control – Dealing with limited generator or shore side power
Power Assist – Boosting the capacity of shore or generator power
LCD display for parameter setting and error messages
Programming auxiliary relay (x 3)

Battery Charger–
Adaptive 4-stage charge characteristic: Bulk-Absorption-Float-Equalize
The right amount of charge: Variable Absorption Time
Preventing damage due to excessive gassing: The Battery Safe Mode
Less maintenance and aging when the battery is not in use: The Equalize Mode
2 outputs to charge 2 battery banks
To increase battery life: Temperature Compensation
Battery Voltage Sense

Super Solar Inverter ~
PURE SINE WAVE Inverter with ATS; Battery Charger and Solar Charge Controller
Connect with Solar system directly.
Smart; powerful and successfully


MODEL NO. PM-1500SSL-12X (12 Volt) [1]
PM-1500SSL-24X (24 Volt)
PM-1500SSL-48X (48 Volt)
Ventilation Forced cooling
Temperature Operation
-20°C ~ +70°C
-25°C ~ +80°C
a. Output short circuit
b. Over load
c. Battery voltage too high
d. Battery voltage too low
e. DC voltage ripple too high
f. Temperature Sensor
  Transformer ∨(105°C)
  Electronic & Powerstage ∨(70°C)
  BTS-3 ∨(50°C)
Humidity 0~95% (non condensing)
Power control Function
Power assist Function
Uninterrupted AC power ∨(less than 10 msec)
Adaptive 4-stage charge
Two output to charge 2 battery banks
Auxiliary Relay X 3
Battery voltage sensor
Battery Temperature sensor (BTS-3)
Remote control port
Input Voltage Range (VDC) 9.5~16V / 19~32V / 38~64V
Output Voltage (VAC) 185~240 VAC / 90~120 VAC
Output Frequency 50Hz / 60Hz ± 0.1%
Output Waveform Pure sinewave
Output Voltage THD < 5%
Power Factor (All Loads)
No linger load; crest factor 3 : 1
Cont. Power Output (W)
Under 70°C (cosθ=1.0)
(No derate)
Cont. Power Output (W)
Over 70°C (cosθ=1.0)
Maximum Power (W) 3000W
Maximum Efficiency (%) 82/84/85
Zero-load Power (W) 12W
Input Voltage Range (VAC) 200~250 VAC / 100~125 VAC
Input Frequency 45-55Hz / 55-65 Hz
Power Factor 1
Charge Characteristic 4-stage adaptive / Bulk-Absorption-Float-Equalize
Maximum DC Voltage Ripple (Vrms) < 1.25 V
Charge Current House Battery (A) 70A/40A/20A
Charge Current Starter Battery (A) 4A
Absorption Voltage Default (VDC) 14.4V / 28.8V / 57.6V
Float voltage Default (VDC) 13.8V / 27.6V / 55.2V
Equalize Voltage default (VDC) 13.2V / 26.4V / 52.8V
Output Charge Voltage (min ~ max) 8V~16V / 11V~32V / 22V~64V
Battery Temperature sensor BTS-3
System voltage ratings 12; 24; 48 Vdc
Current ratings-Battery Charge Control 40A
Accuracy 12/24V:≤0.1 % ± 50 mV
48V:≤0.1 % ± 100 mV
Min. voltage to operate 9V
Max. solar array Voc 140V
Max. operating voltage 68V
Total current consumption While operating -25mA; at idle -3mA
High temp shutdown 90°C disconnect solar
70°C reconnect solar
pulse power rating 4500 watts
Response < 5 nanosec
Ambient temperature -40 to +45°C
Storage temperature -55 to +85°C
Humidity 100% (NC)
AC IN Terminal Circuit Breaker 30A (110V) /15A (220V)
Switch-over Time
a. inverter to AC input 0 msec.
b. AC input to inverter 0 msec.
Detection Time AC Input Fault 4 ~10 msec.
Trip Level AC Input to Inverter 90 VAC / 180 VAC
Trip Level Inverter to AC Input 94 VAC / 187 VAC
Min.~ Max. Frequency Range 45-55 Hz / 55-65 Hz
Cabinet / Protecting Class Aluminum / IP20
Dimension (H X W X D) Wall: 298 x 256 x 368
Table: 189 x 285 x 494
Weight (kgs) 30 kgs

[1] X should be 1; output voltage = 90~120 VAC or 2; output voltage = 185~240 VAC

Scroll to Top