Multiple microprocessor design base.
Compatible with both linear & non-linear load.
Stronger charger to support batteries of 600AH up.
24 hours operation on the inverter.
DC start and automatic self-diagnostic function.
THD less than 3%.
High efficiency design to save electricity.
Low heat dissipation in long time operation.
Design to operate under harsh environment.
3U 19″ Rack Mount or WALL Mounted design.
DC priority or AC priority selectable

PURE SINE WAVE inverter with built in AC Charger and LCD Display
Connect batteries and operate it as UPS.
This unit will be a UPS unit.


Model >PM-8000LC-48
Capacity VA / Watt >8KVA / 8000W
Input Nominal Voltage >220Vac only
Voltage Range Acceptable Voltage Range >120-280Vac
Frequency >50Hz / 60Hz ( 45Hz – 70Hz)
Line Low Transfer >120VAC ± 2%
Line Low Return >130VAC ± 2%
Line High Transfer >280VAC ± 2%
Line High Return >260VAC ± 2%
Output Voltage >200 / 220 / 230 / 240Vac (re-settable via LCD panel)
Voltage Regulation (Batt. Mode) >< 3% RMS for entire battery voltage range
Frequency >50Hz or 60Hz
Frequency Regulation (Batt. Mode) >± 0.1Hz
Power Factor >1.0
Waveform >Pure Sinewave
Effiecincy >> 80%
Overload Protection Line Mode >Circuit Breaker
Battery Mode >110% ~ 150% for 30 sec. ; >150% for 200ms
Transfer Time Typical >< 8 ms.
Battery Battery Voltage >48Vdc (42~62)
Backup Time (at full load) >long time available
Max. Charging Current
(3 steps selectable)
>60 / 80 / 100 Amp
Display LCD LCD >UPS status; I/P&O/P Voltage Frequency; Load%;
Battery Voltage & %; Charge current; Temperature;
LED >Normal (Green); Warning (Yellow); Fault (Red)
Battery Mode >Beeping every 4 seconds
Low Battery >Beeping every second
UPS Fault >Beeping Continuously
Overload >Beeping twice per second
Environment Operation Temperature >0-40 °C ; 32-104 °F
Relative Humidity >0-95% non-dondensing
Audible Noise >Less than 55dBA (at 1M)
Physical Net Weigh (Kgs) >55
(WxHxD) mm Wall Mounted >415 x 600 x 260

* Specifications are subjected to change without prior notice.

Scroll to Top